Time relay 12-240V AC/DC type: PCM-06/U EXT10000083

Dual function relay PCM-06/U. It is used to perform the functions of delayed shutdown (mode A) and delayed on (mode B). The relay is triggered with a supply voltage in the range of 12 ÷ 240VAC/DC. In mode A, the relay operates up to 10 minutes after a power failure. This mode can be used, for example, to control bathroom fans. In mode B, the relay will be switched on after the set time t has elapsed, therefore this mode can be used, for example, for acoustic signaling of the moment of engine start. After the signal (of length t), the motor will be turned on. The device is supplied with a voltage in the range of 12 ÷ 240V AC/DC.

Technical data:

• dimensions: 90 x 17.5 x 66 mm
• Rated Supply Voltage: 12 ÷ 240 V AC / DC
• Maximum contact voltage: 250 V
• Use category: AC1
• Maximum relay power: 2000 VA
• number of changeover contacts: 2
• relay current: 8 A
• rated current consumption: 6 mA (850 mW)
• IP protection class : 20
• casing mounting: TH35 rail
• power terminals: A1, A2
• supply voltage tolerance: -5 ÷ +10 %
• power supply voltage indicator: LED, green
• nominal frequency: 50 / 60 Hz
• number of operating modes: 2 (A, B )
• time setting range t: 0.1 seconds ÷ 1 hour
• time setting accuracy: 5%
• time repeatability: 0.2%
• time setting: 2x potentiometer (rotary + step)
< li>Relay status and timing indicator: LED, red
• Number of connection terminals: 8
• Connection wire cross section: 0.2 ÷ 2.5mm²
• operating temperature: -20 ÷ +60 °C
• work position: any
• protection class: II
• overvoltage category: II
• pollution degree: 2< /li>
• surge voltage: 1.5 kV

Advantages:

• operating modes: delayed on, delayed ;early shutdown
• indication of supply voltage - green LED
• indication of relay status - red LED
• high accuracy of time measurement
• relay output - two changeover contacts with a maximum load capacity of 8 A
• single module housing